panucatt.com

The HELIOS heated bed is a sleek PCB based 3D printing platform that uses copper traces as the heating element. It is commonly used to prevent layer warping when printing ABS or PLA. It has the same hole patterns as the popular Prusa PCB Bed (209mmx209mm) so it is a drop in replacement for 200mm x 200mm build area beds. The overall dimensions has been increased to provide more space for the mounting holes and widen the power tracks supplying the traces. The PCB is 1/8” thick (2x that of the regular beds) to minimize warping and provide rigidity to allow mounting flexibility.

This new design allows several mounting options including using only 3 points for ease of leveling and countersunk screw holes are provided to keep the top surface flat. The heating traces face up and requires a glass or aluminum plate to provide a clean flat surface and help spread heat evenly.

Connecting thick power wires is now easier by utilizing wire terminals and secured by screws to the PCB. Two slots are provided for tie wrapping if required. Pads for mounting the thermistors is provided near the center of the bed and routes to two though hole solder pads near the LED for easy connection ( no more taping the thermistor wire under the bed).

The bed has a [+] and a [-] terminal to power up the power LED correctly.

Makes sure you have at least 12 Amps of spare from your power supply to power the Helios Heated bed. During cold starts the bed can draw a lot of power then taper as it gets hot. The recommended wire size is 12 to 14AWG, you can use 16AWG for shorter wire runs.