Azteeg X1 3D Printer Controller v2.0 RoHS

Description

Description:

The Azteeg X1 3DP is an open source controller designed to be used in RepRap 3D Printers and similar cartesian based machines including CNCs. It has all the features needed to run all current and future single extruder designs. Will work with Prusa Mendel, Mendel Max, Ordbot, Printrbot and most 3D printers

The Azteeg X1 is based on Sanguino/Sanguinololu and is compatible with most Arduino based firmware(Sprinter, Marlin, Repetier, plus others.). It is pin to pin compatible with the Sanguinololu with the addition of a FAN PIN. The X1 features mostly SMT parts to ease production and reduce cost.

Compatible with Pololu and Stepstick stepper motor drivers with the ability to use an external power source for the motors with higher voltages.

The Azteeg X1 3DP is your low cost, compact and expandable 3DP printer controller. Fully Assembled except for the white connectors where you have a choice between right angle and vertical orientation. Soldering iron required.

For more information visit the Azteeg X1 reprap.org wiki page

Features:

Atmel ATMEGA1284P with FT232RL FTDI USB chip. (ATMEGA 644P on v1.0)
RoHS Compliant
Compatible with Sprinter, Marlin, Repetier, others.
Mosfet control for 1 extruder and 1 hotbed
Extra PWM control for small fan or LEDs
3 end stops and 2 thermistor inputs
12-30v input high efficiency switching Power supply @ 500ma max
Dedicated uSD card female header [SDRAMPS compatible]
Low RDSon Mosfets for less heat buildup
Input power selector for micro controller [USB or internal regulator]
Secondary power input for stepper motors.
i2C, Tx1 serial, +5, GND, SPI and ADC pins on the expansion ports
Fast acting blade fuse
Both right angle and vertical connector sets included
Lots of LEDs, Rx/TX serial, PWR, hot end and hot bed.

What's in the box:

Azteeg X1 3DP controller board with Arduino Bootloader and Test Firmware
Selected connector set option

Documentation:


Connectors

Stepper Drivers

Heated Bed

Endstops

Thermistors